|
Alinco DR- 510 mods
NOTICE: TO ALL CONCERNED Certain text files and messages contained on this site deal with activities and devices which would be in violation of various Federal, State, and local laws if actually carried out or constructed. The webmasters of this site do not advocate the breaking of any law. Our text files and message bases are for informational purposes only. We recommend that you contact your local law enforcement officials before undertaking any project based upon any information obtained from this or any other web site. We do not guarantee that any of the information contained on this system is correct, workable, or factual. We are not responsible for, nor do we assume any liability for, damages resulting from the use of any information on this site.
DR510.1
Date: 7 Jul 90 04:22:14 GMT
From: [email protected] (Robert Casey)
Subject: Alinco DR510 Crossband Repeater Mod
To: [email protected]
DR-510 - Vehicular Extender Modification
How to do it
1. Remove bottom cover
2. Remove 2 Phillips screws at corners of subtone board
(small board near center in front) and move the tone board out of
the way.
3. Solder an 16V electrolytic capacitor
(10MFD to 100MFD but best to use 40MFD to
50MFD) as follows:
A. Neg (-) lead to pin 8 on device (IC) labeled - M54959P
B. Pos (+) lead to pin 3, counting from left while facing front
of transceiver of the white 11 pin connector.
ANT Power cord
-----------------Rear----------------------------
l_l_l_l_l_l_l_l
l M54959P l
l_____________l (-)
l l l l l l l l------47uF+
/(+)
/
[][][][][][] [][][X][][][][][][][][]
------------------Front---------------------------
4. Remove top cover and faceplate of transceiver. Be careful of speaker wires!
A. To remove faceplate:
1. Remove main dial knob and retaining nut.
2. Remove mic. socket retaining ring.
3. GENTLY lift tabs, located approximately 3/4" in from each side,
on top of faceplate and "rotate" toward front of the transceiver.
4. When tabs are "free", turn transceiver over and repeat
the process. Remember - gently!
5. Set free plate aside.
CONTINUED IN DR510.2
|
|