|
Yaesu FT- 2700RH mods
NOTICE: TO ALL CONCERNED Certain text files and messages contained on this site deal with activities and devices which would be in violation of various Federal, State, and local laws if actually carried out or constructed. The webmasters of this site do not advocate the breaking of any law. Our text files and message bases are for informational purposes only. We recommend that you contact your local law enforcement officials before undertaking any project based upon any information obtained from this or any other web site. We do not guarantee that any of the information contained on this system is correct, workable, or factual. We are not responsible for, nor do we assume any liability for, damages resulting from the use of any information on this site.
ft2700rh.2
Testing:
You should see the 2700 scanning between channels #1 and #2 at a rate of
about 3 cps. Open the squelch and you should see the tx coming on the
air. Close the squelch and scanning should resume. Note that the rx
volume control has no effect on audio level going out on the air.
Now the pot VR1 will need to be adjusted. There are 3 ways of doing that:
1. Use reports from other stations
2. Better than that, use the old VU METER trick.
3. Best, use a deviation monitor.
continued in ft2700rh.3
Downloaded From P-80 International Information Systems 304-744-2253
|
|
