|
Modification for Yaesu FT- 411
NOTICE: TO ALL CONCERNED Certain text files and messages contained on this site deal with activities and devices which would be in violation of various Federal, State, and local laws if actually carried out or constructed. The webmasters of this site do not advocate the breaking of any law. Our text files and message bases are for informational purposes only. We recommend that you contact your local law enforcement officials before undertaking any project based upon any information obtained from this or any other web site. We do not guarantee that any of the information contained on this system is correct, workable, or factual. We are not responsible for, nor do we assume any liability for, damages resulting from the use of any information on this site.
FT411
Subject: FT-411 OUT OF BAND MODIFICATIONS
Date: 08 Feb 89
1) Open the front cover
2) Locate the C.P.U. unit (it is located on the front cover ).
3) Locate Jumpers 1,2,3 and 4 , These are the band setting Jumpers
4) Jumpers No 1,2 and 4 should be disconnected ,and Jumper No 3 should
be connected.
5) Close the radio .
6) Apply power to the radio and turn it on.
The display will initialize with memory No 1 flashing and the
frequency display will show 1.000
7) Now , adjust the display to the desired lowest receive frequency
When done ,press VFO.
The memory CH will now show 2 flashing .
8) Adjust the display to the desired highest receive frequency
When done press VFO .
The memory CH will now show 3 flashing .
9) Adjust the display to the desired lowest transmit frequency
When done ,press VFO.
The memory CH will now show 4 flashing .
10) Now , adjust the display to the desired highest transmit frequency
When done ,press VFO.
11) The rig is now set for your programed band on transmit and receive.
CONTINUED IN FILE FT411.4
|
|