|
Kenwood TS- 440 Computer Interfacing
NOTICE: TO ALL CONCERNED Certain text files and messages contained on this site deal with activities and devices which would be in violation of various Federal, State, and local laws if actually carried out or constructed. The webmasters of this site do not advocate the breaking of any law. Our text files and message bases are for informational purposes only. We recommend that you contact your local law enforcement officials before undertaking any project based upon any information obtained from this or any other web site. We do not guarantee that any of the information contained on this system is correct, workable, or factual. We are not responsible for, nor do we assume any liability for, damages resulting from the use of any information on this site.
IC10.6
Split (ON/OFF)
______________
SPn;
The Split Status Will be Selected
Where n = 0 for Split OFF
1 for Split ON
Transmit
________
TX;
Radio Will Enter Transmit Mode (PTT Depressed)
Up
__
UP;
The Frequency or Memory Channel
Will Increment One Step
Voice Recall
____________
VR;
The Frequency Will Be Spoken (*)
XIT (ON/OFF)
____________
XTn;
The XIT Function Will be Selected
Where n = 0 for XIT OFF
1 for XIT ON
(Note: XIT is Co-Affected by the RC, RD and RU Commands)
(*) Denotes this Command or Function has not been Tested.
_______________________________________________________________
These additional Kenwood Commands do not apply to the TS-440 and
as such were not defined; but are used in one or more of the other
models and are presented here for your experimentation.
AT Antenna Tuner (Standby)
DI DCL ID (Readout of Callsign)
DS DCL System (On/Off)
HD Scan Hold
LO Local (TS-940 : Remote control of SLOPE, TUNE, VBT)
MS Memory Scan
OS Offset
SH Slope Tune High
SL Slope Tune Low
ST Step
TN Tone Number (SubTone)
TO Tone (SubTone On/Off)
VB VBT
|
|