|
Icom 2400A cross band repeater function
NOTICE: TO ALL CONCERNED Certain text files and messages contained on this site deal with activities and devices which would be in violation of various Federal, State, and local laws if actually carried out or constructed. The webmasters of this site do not advocate the breaking of any law. Our text files and message bases are for informational purposes only. We recommend that you contact your local law enforcement officials before undertaking any project based upon any information obtained from this or any other web site. We do not guarantee that any of the information contained on this system is correct, workable, or factual. We are not responsible for, nor do we assume any liability for, damages resulting from the use of any information on this site.
IC2400A.1
HM-56 New Autodialer Mic with 32 memories for 2400/2500A
MIC GAIN adj for 2400A is R13 (70%dev adj +/- 3.5 KHZ.)
____________________________________________________________
IC 2400A CROSS BAND REPEATER OPERATION
1) put both bands in "VFO" mode
2) set up one band with repeater offset and tone (if needed)
3) set other band for simplex
4) turn off radio
5) get a Octopus to help you, with the power off, push and
hold following buttons: MONI, MHZ, SET, & DOWN button on
microphone, while holding all above, turn on power.
Note- for Icom 2500A substitute CALL button for SET in
step 5.
TO GET OUT OF REPEATER OPERATION:
With power on, push SET button and hit MHZ button
Note- Some rigs will have to have D9 diode cut on Logic
board, however, later rigs do not have this diode.
Anybody have out of band RX/TX mods for this rig? Please
send to Bill N2EZG @ KC2AZ PBBS in Elmira N.Y.
**NOTE** If above does not work, reset the CPU as per Operation Manual before
tearing in and looking for diode, I had to reset mine, and my 2400A serial#
02402 did not have the diode. Info obtained from "Gary" at Icom Bellevue
Service Dept.
|
|
