|
Mod for Icom 24at
NOTICE: TO ALL CONCERNED Certain text files and messages contained on this site deal with activities and devices which would be in violation of various Federal, State, and local laws if actually carried out or constructed. The webmasters of this site do not advocate the breaking of any law. Our text files and message bases are for informational purposes only. We recommend that you contact your local law enforcement officials before undertaking any project based upon any information obtained from this or any other web site. We do not guarantee that any of the information contained on this system is correct, workable, or factual. We are not responsible for, nor do we assume any liability for, damages resulting from the use of any information on this site.
IC24AT.6
LIGHT + 7 = Power Save deactivated (use this for packet operation)
LIGHT + 8 = Power Save (minimum - 0.125 / 0.5 second)
LIGHT + 9 = Power Save (maximum - 0.125 / 2.0 seconds)
LIGHT + A = ???? Unknown action
LIGHT + B = ???? Unknown action
LIGHT + C = ???? Unknown action
LIGHT + D = ???? Unknown action
LIGHT + # = ???? Unknown action
LIGHT + B + # = RX Extended Range enable
This requires that diode D13 is removed (left diode on
CPU board). Note that this diode has already been removed
by ICOM at the factory on many units. Be sure to hold
these keys down until the activity display stops and is
showing a receive frequency.
FUNC + A = Reset the CPU (this will clear all the memory channels to the
factory defaults)
If you have any corrections or additions, please send them to NM1D @ WB1DSW.
Downloaded From P-80 International Information Systems 304-744-2253
|
|