|
Modification for Icom 32at
NOTICE: TO ALL CONCERNED Certain text files and messages contained on this site deal with activities and devices which would be in violation of various Federal, State, and local laws if actually carried out or constructed. The webmasters of this site do not advocate the breaking of any law. Our text files and message bases are for informational purposes only. We recommend that you contact your local law enforcement officials before undertaking any project based upon any information obtained from this or any other web site. We do not guarantee that any of the information contained on this system is correct, workable, or factual. We are not responsible for, nor do we assume any liability for, damages resulting from the use of any information on this site.
ic32at.14
From: [email protected]
MODS FOR NEW MODEL ICOM 32AT
1. Remove battery and back screws (4).
2. Loosen (only) top screws (2), bottom screws (4), and PTT
screws (2).
3. Lift bottom of front panel 1/2" and slide down 1/2".
4. Unplug speaker/mic connector. Try not to disconnect ribbon cable.
5. There are five diode locations to the LEFT of the back of the speaker.
(Note: If they are to the RIGHT of the back of the speaker, and if there
are some components above the back of the speaker, you have an older model.
Just move the diodes until they are in positions 3 & 5 (counting from the
top down). This will only enable expanded UHF & 10 MHZ digit entry, not
crossband repeater operation.)
6. Diodes should be found in locations 2 & 4 counting from the top.
7. If so, move the diode from location 4 to location 1 (leave the diode at 2).
8. This expands UHF receive & allows keypad entry of the 10 MHZ digit.
continued in file ic32at.15
|
|