|
Modification for Icom 32at
NOTICE: TO ALL CONCERNED Certain text files and messages contained on this site deal with activities and devices which would be in violation of various Federal, State, and local laws if actually carried out or constructed. The webmasters of this site do not advocate the breaking of any law. Our text files and message bases are for informational purposes only. We recommend that you contact your local law enforcement officials before undertaking any project based upon any information obtained from this or any other web site. We do not guarantee that any of the information contained on this system is correct, workable, or factual. We are not responsible for, nor do we assume any liability for, damages resulting from the use of any information on this site.
IC32AT.2
OUT OF BAND MOD FOR THE IC-32AT
This mod allows the unit to RX-TX outside both ham bands, plus
function as a crossband repeater! BE CAREFUL THAT YOU DON'T
INADVERTENTLY TRANSMIT!
DISASSEMBLY
1. Remove the battery.
2. Loosen but do not remove the two screws holding the PTT switch
plate.
3. Remove the 4 screws on the back of the radio.
4. Now remove the front of the HT by carefully lifting the bottom
edge and then pulling it down so it clears the top of the HT. Be
carefull as there is a ribbon cable attached.
5. Unplug the Speaker/Mic plug from the main chassis to allow the
front conver to be fully opened.
MODIFICATION (Refer to figure 1.)
1. Remove D907
2. Remove D913.
3. Move D912 down to next pad. (D???, bottom location)
4. Add diodes Da and Db (1N914 or Equiv.).
CONTINUED IN FILE IC32AT.9
|
|