|
BAND EXPANSION MODIFICATION FOR ICOM MICRO
NOTICE: TO ALL CONCERNED Certain text files and messages contained on this site deal with activities and devices which would be in violation of various Federal, State, and local laws if actually carried out or constructed. The webmasters of this site do not advocate the breaking of any law. Our text files and message bases are for informational purposes only. We recommend that you contact your local law enforcement officials before undertaking any project based upon any information obtained from this or any other web site. We do not guarantee that any of the information contained on this system is correct, workable, or factual. We are not responsible for, nor do we assume any liability for, damages resulting from the use of any information on this site.
===== BAND EXPANSION MODIFICATION FOR ICOM MICRO2 =====
1. Remove battery.
2. Remove 4 screws securing batter. Slide from fron panel.
3. Remove small black screw below PTT switch.
4. Carefully separate the fron speaker from the body by pulling front
and rear down toward battery. Flip it over.
5. Next remove steel chassis assembly by gently prying up the sides,
lift up, fold it down.
6. Solder in new diode next to Q131 and Diode D113. Looking at Diode
Matrix with top of radio to the top, add diode to the empty pad to
the left of diode D119. There are 3 points of connection on the
diode pad. Two on the left and on centered vertically on the right.
The diode should be installed between the lower left and the right
centered connection. (Arrow on diode points to right centered connection.)
7. Reset CPU by following instruction manual page 23.
----------------------------------
***->Be careful not to transmit out-of-band, or accidentally operate on
any non-amateur, unless you are authorized to do so.
DO NOT JEOPARDIZE YOUR LICENSE!
[EOF]
|
|
