|
Nicad Charger Plans
NOTICE: TO ALL CONCERNED Certain text files and messages contained on this site deal with activities and devices which would be in violation of various Federal, State, and local laws if actually carried out or constructed. The webmasters of this site do not advocate the breaking of any law. Our text files and message bases are for informational purposes only. We recommend that you contact your local law enforcement officials before undertaking any project based upon any information obtained from this or any other web site. We do not guarantee that any of the information contained on this system is correct, workable, or factual. We are not responsible for, nor do we assume any liability for, damages resulting from the use of any information on this site.
*********************************************************************
A NICAD BATTERY CHARGER USING VOLTAGE AND CURRENT LIMITING TECHNIQUES
*********************************************************************
WRITTEN BY ANDREW - VK4TEC DATE: 2nd October 1992
_________ _________ _______
3 [ ] 2 3 [ ] 2 [ ]
I O-----[ LM317 ]----o--------[ LM317 ]----[ R3 ]----o----O O
N [_________] | [_________] [_______] | U
P O | _|_ | | O T
U | 1 | [ ] 1 |______________________| | P
T | | [ R ] | U
| | [ 2 ] | T
| | [___] |
| | | |
| o---------o |
| | |
| _|_ |
| [ ] RESISTOR 1 - SETS VOLTAGE LEVEL |
| [ R ] |
| [ 1 ] RESISTOR 2 - SET AT 120 OHMS |
| [___] |
| | RESISTOR 3 - SETS CURRENT LEVEL |
| | |
|----------o---------------------------------------------------|
O---------------------------------------------------------------------O
| |
| SOURCE ---< VOLTAGE REGULATOR >---< CURRENT REGULATOR >--- BATTERY |
| |
O---------------------------------------------------------------------O
NOTES :-
1. NICAD BATTERY CHARGER USES TWO LM317 ADJUSTABLE VOLTAGE
REGULATORS , ONE AS A VOLTAGE REGULATOR , AND THE SECOND
AS A CURRENT REGULATOR.
2. RESISTOR R1 IS ADJUSTED TO GIVE THE DESIRED NICAD VOLTAGE.
3. RESISTOR R2 IS OF A STT VLLUE , NAMELY 120 OHMS.
4. RESISTOR R3 IS ADJUSTED TO GIVE THE DESIRED NICAD CHARGING
CURRENT. THE VALUE OF THIS RESISTOR IS CALCULATED BY :-
1.25 Volts
I ( CURRENT ) = -------------- Amphere
RESISTOR 3
5. THE VALUE OF 1.25 VOLTS IS PRESENT ON THE ADJUST PIN OF AN
LM317 VOLTAGE REGULATOR.
6. THE CHARGING RATE SHOULD BE CHOSEN AS TO GIVE A CHARGING RATE
OF ABOUT 1/10 OF THE NICAD CURRENT CAPACITY.
EG :- TO CHARGE A 1000 mAH BATTEYY PCCK.
CHARGE CURRENT REQUIRED IS :- 1000 / 10 = 100 mA
TO CALCULATE THE VALUE OF R3, APPLY THE FORMULA.
1.25 Volts
I ( CURRENT ) = ----------------
RESISTOR 3
1.25 Volts
OR RESISTOR 3 = ---------------
100 mA
WHICH GIVES A VALUE OF 125 Ohms. ( CHOOSE NEAREST VALUE ).
7. THE TIME FOR CHARGE IS ROUGHLY 14-16 HOURS AT THIS CHARGING
RATE. A FASTER CHARGE WILL DECREASE TIME TAKEN.
8. THE CURRENT STAYS CONSTANT, AND THE VOLTAGE RISES WITH TIME.
9. TRICKLE CHARGE IS OFTEN 1/100 OF THE NICAD CAPABILITY.
EG :- 1000 mAH BATTERY , TRICKLE CHARGE = 10 mA.
10. THE MM31 VOLTAG REGULATOR IS DESIGNED TO PROVIDE
GREATER THAN 5 mA CURRENT
LESS THAN 500 mA CURRENT
KEEP WITTHIN THESE DESIGN PARAMETERS !!!!
11. THE PINOUTS FOR THE LM317T VOLTAGE REGULATOR IS AS FOLLOWS :-
--------- ___________
> O < 3 [ ] 2
--------- O------[ LM317 ]------O
| | PIN 1 - ADJUST [_________]
| LM317 | |
| | PIN 2 - OUTPUT | 1
--------- |
# # # PIN 3 - INPUT O
# # #
1 2 3
12. A SIMPLE CHART IS INCLUDED TO AID CHOICE OF CORRECT VALUE FOR
RESISTOR 3.
O--------------------------------------------------------------O
O RESISTANCE ( OHMS ) O CHARGING CURRENT ( mA ) O
O--------------------------------------------------------------O
2.7 460
3.3 380
3.9 320
4.7 270
5.6 220
6.8 180
8.2 150
10.0 125
12.0 100
15.0 83
118.0 70
22.0 60
27.0 50
33.0 40
39.0 32
47.0 27
56.0 20
68.0 18
82.0 15 000.0
120.0 10
150.0 8
******************
END OF FILE
******************
|
|
