|
Equipment Modification
NOTICE: TO ALL CONCERNED Certain text files and messages contained on this site deal with activities and devices which would be in violation of various Federal, State, and local laws if actually carried out or constructed. The webmasters of this site do not advocate the breaking of any law. Our text files and message bases are for informational purposes only. We recommend that you contact your local law enforcement officials before undertaking any project based upon any information obtained from this or any other web site. We do not guarantee that any of the information contained on this system is correct, workable, or factual. We are not responsible for, nor do we assume any liability for, damages resulting from the use of any information on this site.
PCS4000.1
The five second scan resume delay
is sufficient to prevent scanning restart on momentary signal
fades and no signal periods between transmissions of different
stations in a net or in a roundtable. The modification is
fairly simple, requiring the installation of a single diode on
the receiver board.
"Place the set upside down on the bench and remove the
bottom cover. Remove the cover slowly so as not to yank the
speaker wires loose from the PC Board. Locate IC303 near the
front of the receiver board. It can be seen at the lower left
of the photo on page 14 of the Azden PCS-4000 Manual, with the
arrow running from (A), running across it. Pins 3,4, and 5 of
IC303 are tied together on the PC Board. Connect the Anode of a
1N914 or 1N4148 diode to one of these pins. Pins 9 and 10 of
IC303 are tied together on the PC Board. Connect the cathode
end of the diode to one of these two pins. Take care to make
the solder connections as rapidly as possible to minimize the
amount of heat conducted from the pins into the IC.
"Replace the bottom cover and enjoy." That's all there is
to the modification. Have fun with your new modification.
Downloaded From P-80 International Information Systems 304-744-2253
|
|
