|
pcs - mhz tx mod
NOTICE: TO ALL CONCERNED Certain text files and messages contained on this site deal with activities and devices which would be in violation of various Federal, State, and local laws if actually carried out or constructed. The webmasters of this site do not advocate the breaking of any law. Our text files and message bases are for informational purposes only. We recommend that you contact your local law enforcement officials before undertaking any project based upon any information obtained from this or any other web site. We do not guarantee that any of the information contained on this system is correct, workable, or factual. We are not responsible for, nor do we assume any liability for, damages resulting from the use of any information on this site.
pcs6000 138 - 160 mhz tx mod
1. DISCONNECT THE DC POWER AND REMOVE BOTH TOP AND BOTTOM COVERS.
2. REMOVE FOUR (4) FLAT PHILLIPS SCREWS THE HOLD THE BLACK FACE COVER TO THE
CHASSIS.
3. CAREFULLY REMOVE THE BLACK FACE COVER FROM THE CHASSIS.
4. AFTER THE FACE COVER IS OFF,REMOVE FOUR (4) SMALL PHILLIPS SCREWS HOLDING
THE PC BOARD TO THE CHASSIS AND REMOVE ONE (1) FLAT PHILLIPS SCREW ABOVE
THE MICROPHONE CONNECTOR.
5. CAREFULLY REMOVE TH PC BOARD.(NOTE): A LITTLE PRYING MAY BE NECESSARY,
HOWEVER, EXTREME CARE MUST BE TAKEN NOT TO BEND THE PIN CONNECTORS.
6. AFTER THE BOARD HAS BEEN REMOVED, TURN THE BOARD OVER AND LOCATE DIODE
D-207.
7. CAREFULLY REMOVE THIS DIODE FROM THE BOARD. THIS DIODE MAY BE
DESOLDERED OR CUT OUT.
8. NOW REPLACE ALL OF THE COMPONENTS IN THE OPPOSITE ORDER IN WHICH YOU
REMOVED THEM.
9. RECONNECT THE DC POWER AND THE ANTENNA AND YOU ARE READY TO TRANSMIT
FROM 138.000 TO 160.000 MHZ.
BE SURE TO READ OVER SEVERAL TIMES BEFORE ATTEMPTING...GOOD LUCK...BILL
|
|