|
Realistic Pro- 34 Mods
NOTICE: TO ALL CONCERNED Certain text files and messages contained on this site deal with activities and devices which would be in violation of various Federal, State, and local laws if actually carried out or constructed. The webmasters of this site do not advocate the breaking of any law. Our text files and message bases are for informational purposes only. We recommend that you contact your local law enforcement officials before undertaking any project based upon any information obtained from this or any other web site. We do not guarantee that any of the information contained on this system is correct, workable, or factual. We are not responsible for, nor do we assume any liability for, damages resulting from the use of any information on this site.
PRO34.11
5. Now you will see the RF boad mounted to the metal support frame, The
BNC (antenna) conector leads and the volume control power switch leads
are soldered directly to the board. Carefully desolder these 4 connections.
6. At the bottom of the RF board there is a IF Can transformer that has a small
wire as a groundign strap soldered directly to it. Desolder this as well.
7. There will be some wires from the volume controle knob to the PC board that
are socketed. Remove the plug from the ~F board (needle nose pliers work)
8. There will also be a similar wire (small sheilded ) from the squelch control
to the RF board wich is also Socketed. Remove the plug from the RF board.
(Again Needle Nose Pliers work good here)
9. Remove the 4 thredded stand-offs from the RF Board (these Hold the RF board to
the internal mettal frame and are where the screws that hold the back of the
case on go.) Use a nut driver or Needle Nose Pliers.
CONTINUED IN FILE PRO34.2 - REQUEST FROM SERVER
Downloaded From P-80 International Information Systems 304-744-2253
|
|