|
Realistic Pro- 34 Mods
NOTICE: TO ALL CONCERNED Certain text files and messages contained on this site deal with activities and devices which would be in violation of various Federal, State, and local laws if actually carried out or constructed. The webmasters of this site do not advocate the breaking of any law. Our text files and message bases are for informational purposes only. We recommend that you contact your local law enforcement officials before undertaking any project based upon any information obtained from this or any other web site. We do not guarantee that any of the information contained on this system is correct, workable, or factual. We are not responsible for, nor do we assume any liability for, damages resulting from the use of any information on this site.
PRO34.12
13. There is a small socketed wire that leads from the small power pc board on the
metal frame that goes under it and is pluged into the Logic board. Lift
the metal frame up and remove the power plug from the PC board. Place the
metal frame with|the rest of your parts pile.
14. You are have the component side of the Logig board exposed now. There are
2 small phillips screws at the bottom of the PC board (where the Battery
compartment WAS) Remove them.
15. Once you have the the last 2 screw removed the Logic board is free. The
speaker wires lead from the speaker to the logic board on the bottom side.
These are soldered in but there is enough play in them to allow you to
make the mods.
16. NOTE: The keyboard lock switch is a funky little piece of plastic with
a sliding stainless metal contactor that is just wedged inbetween the
front case and the logic board. Remove both the switch contacts and the
plastic switch. (best know it now or loose them in the carpet)
CONTINUED IN FILE PRO34.6
Downloaded From P-80 International Information Systems 304-744-2253
|
|