|
Realistic Pro- 34 Mods
NOTICE: TO ALL CONCERNED Certain text files and messages contained on this site deal with activities and devices which would be in violation of various Federal, State, and local laws if actually carried out or constructed. The webmasters of this site do not advocate the breaking of any law. Our text files and message bases are for informational purposes only. We recommend that you contact your local law enforcement officials before undertaking any project based upon any information obtained from this or any other web site. We do not guarantee that any of the information contained on this system is correct, workable, or factual. We are not responsible for, nor do we assume any liability for, damages resulting from the use of any information on this site.
PRO34.5
16. NOTE: The keyboard lock switch is a funky little piece of plastic with a
sliding stainless metal contactor that is just wedged inbetween the front
case and the logic board. Remove both the switch contacts and the plastic
switch. (best know it now or loose them in the carpet)
17. On the component side of the PC board you will see lots of nifty surface
mounted compone]ts, a fat little barrel capacitor (used for maintaining
the channel freqs while you change the batteries.. and make
modifications:) near the edge of the PC board you will see a couple of
small diodes moutned vertically. These will be labeled on the PC board as
D10 and D11, you will also see a place for another diaode to be soldered
in but was not installed at the factory.. this is D9.
CONTINUED IN FILE PRO34.13
|
|