|
TRANSMIT ENABLE FOR MARS AND CAP FREQUENCIES FOR THE TS S
NOTICE: TO ALL CONCERNED Certain text files and messages contained on this site deal with activities and devices which would be in violation of various Federal, State, and local laws if actually carried out or constructed. The webmasters of this site do not advocate the breaking of any law. Our text files and message bases are for informational purposes only. We recommend that you contact your local law enforcement officials before undertaking any project based upon any information obtained from this or any other web site. We do not guarantee that any of the information contained on this system is correct, workable, or factual. We are not responsible for, nor do we assume any liability for, damages resulting from the use of any information on this site.
TRANSMIT ENABLE FOR MARS AND CAP FREQUENCIES FOR THE TS430S
For MARS and CAP transmit capability, a minor change is required:
1. Unplug the DC power cable.
2. Remove the top and bottom covers of the set.
3. Locate the RF unit connector 10. Diode D39 is near the connector
(labeled D39 on the circuit board). Take a small pair of diagonal
cutters and clip the lead at the top of the bend.
4. Locate IC-2 on the Control Unit, under the IF unit. Resistor R148
is near IC-2, clip the resistor lead.
5. This completes the modification. Reassemble the unit, being careful
not to pinch any leads.
***->Be careful not to transmit out-of-band, or accidentally operate on
any non-amateur, unless you are authorized to do so.
DO NOT JEOPARDIZE YOUR LICENSE!
Downloaded From P-80 International Information Systems 304-744-2253
|
|