|
Homemade Gravity Bong
NOTICE: TO ALL CONCERNED Certain text files and messages contained on this site deal with activities and devices which would be in violation of various Federal, State, and local laws if actually carried out or constructed. The webmasters of this site do not advocate the breaking of any law. Our text files and message bases are for informational purposes only. We recommend that you contact your local law enforcement officials before undertaking any project based upon any information obtained from this or any other web site. We do not guarantee that any of the information contained on this system is correct, workable, or factual. We are not responsible for, nor do we assume any liability for, damages resulting from the use of any information on this site.
Warning: This bong is extremely powerful. A single hit from this bong can cause sickness and vomiting. Lightweights should not use this bong.
Materials
- A large plastic bottle with cap
- A large bucket that can hold water
- A pipe or tube (I used a pen tube)
- A bowl or tin foil
- A soldering iron
- A sharp knife that can make clean cuts through plastic
- Water
- Marijuana
- Lighter
Construction
First, take off the bottle cap and burn a hole through it with the soldering iron. The hole should be about the size of the tube your going to use. Now, while the plastic is still hot, shove the tube through it. The melted plastic should form an airtight seal around the pen. If there is not an airtight seal use the soldering iron to melt the plastic of the cap and, if using a plastic tube such as a Bic pen, the tube together. When the seal is airtight, put your bowl on the tube, or if using tin foil form a bowl around the top of the tube (this can be a little tricky).
Now, take the plastic bottle and cut the bottom off. Don't take too much off as this is your chamber and you want it to be as big as possible.
Next, fill the bucket with water with enough water so that when you place the bottle in the water, the bowl and cap sticks out. Screw the cap on and your bong is ready.
Use
Now for the fun part. Fill the bowl with weed. Take your lighter and hold the flame on the bowl. Slowly, very slowly, pull the bottle up. Keep the flame on the bowl. The bottle should be filling with beautiful, creamy smoke. When the bottle is at the top of the water (keep the bottle in the water), unscrew the cap and place it on the side (all the marijuana should be ash now). Place your mouth on the mouth of the bottle and inhale. As you inhale, push the bottle back into the water. Push the bottle until it hits the bottom of the bucket. Hold it in for as long as you can, then exhale.
|
|