|  | 
							
							
								|  |  |  |  
								|  | register |
										bbs |
										search |
										rss |
										faq |
										about |  |  
								|  | meet up |
										add to del.icio.us |
										digg it |  |  
								|   | Instructions for the Zero- G Toilet from 2001ZERO GRAVITY TOILETPassengers are required to read instruction before use.
 
 1.  The  toilet  is  of  the  standard  Zero-gravity  type.   Depending  on
 requirements, system A  and/or system B  can be used,  details of which
 are clearly marked in the toilet compartment.  When operating system A,
 depress  lever  and  a  plastic  dalkron  eliminator  will be dispensed
 thorough the slot immediately  underneath.  When you have  fastened the
 adhesive lib, attach to connection marked by the large "X" outlet hose.
 Twist the  silver coloured  ring one  inch below  the connection  point
 until you feel it lock.
 
 2.  The toilet is now ready for use.  The Sonovac cleanser is activated  by
 the small switch on the lip.  When securing, twist the ring back to its
 initial  condition,  so  that  the  two orange lines meet.  Disconnect.
 Place the  dalkron eliminator  in the  vacuum receptacle  to the  rear.
 Activate by pressing the blue button.
 
 3.  The controls for system  B are located on  the opposite wall.  The  red
 release switch places the uroliminor into position; It can be  adjusted
 manually up  or down  by pressing  the blue  manual release  button The
 opening is self adjusting.  To secure after use press the green  button
 which  simultaneously   activates  the   evaporator  and   returns  the
 uroliminator to its storage position.
 
 4.  You man leave the lavatory if the green exit light is on over the door.
 If the red light is illuminated, one of the lavatory facilities is  not
 properly secured.  Press the "stewardess"  call button to the right  of
 the  door.   She  will  secure  all  facilities  from her control panel
 outside.  When green exit light go on, you may open the door and leave.
 Please close the door behind you.
 
 5.  To use the Sonoshower, first undress and place all your clot hes in the
 clothes rack,  Enter the  shower.  On  the control  panel to your upper
 right upon  entering you  will see  a "Shower  seal" button.   Press to
 activate.  A green  light will then  be illuminated immediately  below.
 On  the  intensity  knob,select  the  desired setting.  Now depress the
 Sonovac activation lever.  Bath normally.
 
 6.  The sonovac will  automatically go off  after threw minutes  unless you
 activate the "Manual off" over-ride switch by flipping it up.  When you
 are ready to leave, press  the blue "Shower seal" release  button.  The
 door will open  and you may  leave.  Please remove  the velcro slippers
 and place them in their container.
 
 7.  If the red light  above this panel is  on, the toilet is  in use.  When
 the  green  light  is  illuminated  you  may  enter.  However, you must
 carefully  follow  all  instruction  when  using  the facilities during
 coasting (Zero G) flight.  Inside  there are three facilities: (1)  The
 Sonowasher, (2) The Sonoshower, (3) The Toilet.  All three are designed
 to be used under weightless conditions.  Please observe the sequence of
 operations for each individual facility.
 
 8.  Two modes for  washing your face  and hands are  available, The "moist-
 towel" mode and the "Sonovac" ultrasonic cleaner mode.  You may  select
 either mode by moving the appropriate lever to the "Activate" position.
 If  you  choose  the  "moist-towel"  mode, depress the indicated yellow
 button and withdraw item.  When you have finished, discard the towel in
 the  vacuum  dispenser,  holding  the  indicated  lever  in an "active"
 position until  the green  light goes  on...showering that  the rollers
 have passed the towel completely into the dispenser.  If you desire and
 additional towel, press the yellow button and repeat the cycle.
 
 9.  If  you  prefer  the  "Sonovac"  ultrasonic  cleaning mode, depress the
 indicated blue  button.  When  the twin  panels open,  pull forward  by
 rings A and B. For cleaning  the hands, use in this position.   Set the
 timer to  positions 10,  20, 30,  and 40...indicative  of the number of
 seconds required.  The knob to the left, just below the blue light  has
 three settings, low medium or high.  For normal use, the medium setting
 is suggested.
 
 10. After these  settings have  been made,  you can  activate the device by
 switching to  the "ON"  position the  clearly marked  red switch.   If,
 during the washing  operation, you wish  to change the  settings, place
 the "manual off" over-ride switch  in the "OFF" position.  You  may now
 make the change and repeat the cycle.
 
 From 2001:A SPACE ODYSSEY by Arthur C. Clarke
 
 |   |  
								|  | To the best of our knowledge, the text on this page may be freely reproduced and distributed.
 If you have any questions about this, please check out our Copyright Policy.
 
 
  totse.com certificate signatures
 
 
 |  |  
								|  | About | Advertise | Bad Ideas | Community | Contact Us | Copyright Policy | Drugs | Ego | Erotica FAQ | Fringe | Link to totse.com | Search | Society | Submissions | Technology
 |  |  
								|  |  |  |  |